K&M Carbide Cutting Pilot Information
This finely ground carbide cutting pilot designed for use with the K&M neck turning body has four cutting flutes used to remove the âdough-nutâ that can form at the inside neck wall and shoulder junction. If you are noticing the formation of a doughnut, this tool will remove the excess material without affecting the inside neck diameter. This allows for uniform bullet seating and eliminates powder gas restriction. There is also less friction between brass and carbide; this translates into less heat buildup and galling.
Features
- Made Specifically for the K&M Neck Turning Tool
- Carbide reduces friction caused while turning brass
- Cutting teeth on end will remove the dreaded case “doughnut”
Specifications
Material | Carbide |
Minimum Caliber | 243 Caliber, 6mm |
Maximum Caliber | 243 Caliber, 6mm |
Delivery Information
Shipping Weight | 0.068 Pounds |
Reviews
There are no reviews yet