Little Crow Gunworks World’s Finest Trimmer 2 Housing Cutter Assembly Information
When designing the Little Crow Gunworks World’s Finest Trimmer 2, the feature most customers asked for was the ability to interchange trim chambers. Instead of press fitting the trim chambers, like the original WFT, the trim chambers on the WFT2 are a slight slip fit in bearing with a groove cut for an O-ring which creates a press fit.
Changing out trim chambers is accomplished by removing the cutter and pushing out the trim chamber with the knock-out dowel that is provided. Installing the trim chamber is accomplished by setting the trim chamber on a flat surface and steadily pushing the housing onto the trim chamber. Setting the cutter depth is easily adjusted by placing a âmaster caseâ in the trim chamber and sliding the cutter up to the case mouth and tightening down the set screws.
Trimming is just as precise and clean as with the original trimmer. The trim chamber selection on the WFT2 is by specific cartridge, but still trims by case family-just order the largest chamber in the family that you intend to trim. The razor sharp high-speed cutters and the sealed ball bearing incorporated into the trimmer produce an extremely smooth cut. In most cases it will only be necessary to slightly chamfer the inner edge of the case mouth. Most drill chucks have a little wobble to them, but with a little experimentation you can usually find a sweet spot were the WFT runs perfectly true. The less wobble you have the higher r.p.m. you can trim at. Unlike other case trimmers the WFT does not use pilots, the case is supported by the shoulder and body of the case.
Comes standard with the High Speed Steel cutter.
Note: This item by itself will not trim any cases. You must also purchase the WFT2 Trim Chamber inserts for the cartridges that you want to trim.
Made In United States of America
Specifications
Country of Origin | United States of America |
Delivery Information
Shipping Weight | 0.440 Pounds |
Reviews
There are no reviews yet