EGW 2-Piece Full Length Recoil Spring Guide Rod with Recoil Spring Plug 1911 Government Tungsten Information
1911 Guide Rods for any application. Pair these rods with an EGW Recoil Plug for a truly custom gun.
Notes:
Full length guide rods replace the stock spring guide and provide full support of the recoil spring. This allows for even compression of the spring coils as the slide moves to the rear, making the absorption of energy more uniform. Centering the thrust of recoil in this way makes slide cycling consistent and helps with feeding and extraction.
Use of a one piece guide rod makes traditional disassembly of the gun impossible. To disassemble a gun equipped with a one piece guide rod, make sure the gun is not loaded, push the slide to the rear until the slide stop retainer tip lines up with the relief cut in the slide and hold the slide in that position until you remove the slide stop. Then take the slide off the frame in the usual fashion.
Two piece guide rods are designed to offer the same performance of a one piece rod with easier disassembly. These rods have an allen fitting in the end of the rod, which you turn to remove the front end during disassembly. After turning the barrel bushing 1/4 clockwise turn, place your allen wrench in the slot of the rod, turn and remove the end of the rod. You can now remove the spring plug and rod end releasing tension on the slide, then remove the slide as in standard disassembly.
Made In United States of America
Specifications
Finish | Stainless |
Material | Tungsten |
Country of Origin | United States of America |
Compatible With |
1911 Government
|
Delivery Information
Shipping Weight | 0.255 Pounds |