PTG Interchangeable Pilot Screw In Choke Tap Remington Rem Choke 12 Gauge For Sale

PTG Interchangeable Pilot Screw In Choke Tap Remington Rem Choke 12 Gauge Information

This choke tap is for use with interchangeable pilot bushings. It may be used by hand, but best results will be achieved with the use of a lathe. Make sure to remove any existing choke or constriction in barrel before use.

Notes:

• Tru-Choke for use with barrels that are too thin for Win-Choke. Outside diameter .020″ smaller than Win-Choke.
  12 gauge .795″ – 44 tpi, accepts standard Tru-Choke tubes. 20 gauge .675″ – 44 tpi
• Tru-Choke thinwall for over and under, lightweight single shot, side by side with thin barrels. 0.020″ thinner than standard Tru-Choke tubes.
  12 gauge .775″ – 44 tpi, accepts thinwall style tubes only.
• Win-Choke for threading barrels to accept original equipment tubes from Win-Choke, Mossberg AccuChoke, Weatherby, Browning Invector.
  12 gauge .814″ – 32 tpi. 20 gauge 11/16″ – 32 tpi.
• Rem-Choke barrels will accept Rem-Choke and Remington factory tubes.
  12 gauge .814″ – 32 tpi.

Specifications